Cosmo UIM & LIM to FD
#1
400Rwhp Seq Twins Baby!!
Thread Starter
Join Date: Mar 2006
Location: "Sunny" ol England
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
Cosmo UIM & LIM to FD
Im swapping the stock FD Upper and lower intakes for the larger cosmo ones...problem i have is that i need larger secondry injectors but dont want to f*ck about modifying the fuel rail because iv been told the KG parts one wont fit...
Whats the largest injectors i can fit into the cosmo fuel rail without having to modify anything???
Also iv had an adaptor/spacer plate made to increase the overall length of the UIM to the same size as a stock FD but whats the best thing to use as a gasket between the UIM spacer and Throttle??
Thanks...
Rixio
Whats the largest injectors i can fit into the cosmo fuel rail without having to modify anything???
Also iv had an adaptor/spacer plate made to increase the overall length of the UIM to the same size as a stock FD but whats the best thing to use as a gasket between the UIM spacer and Throttle??
Thanks...
Rixio
#2
"Elusive, not deceptive!”
I use the 1680 bosch.
I run no ISC (idle speed control), to clear the ign. coils.
Rewire the RE TPS ( throttle position sensor) to the REW plug.
Barry
I run no ISC (idle speed control), to clear the ign. coils.
Rewire the RE TPS ( throttle position sensor) to the REW plug.
Barry
#3
400Rwhp Seq Twins Baby!!
Thread Starter
Join Date: Mar 2006
Location: "Sunny" ol England
Posts: 362
Likes: 0
Received 0 Likes
on
0 Posts
Did they fit right in? A friend who builds engines spoke to Bosch and they said that their 1680cc injectors are gas injectors or some ****...??? And for them to fit into the rail it needed milling 3-4mm??
Was any modification required to the rail to get them to fit?
Was any modification required to the rail to get them to fit?
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
10-17-20 03:25 PM
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM