cosmo center iron HELP!
#1
cosmo center iron HELP!
so i have a cosmo center iron that i used in my rebuild totally forgetting that the primarys are top feed. so i took out the spacer in the primary injector holes. well now i regret it and i want to run the top feed cosmo primarys. DOES ANYONE KNOW WHERE I CAN BUY THE SPACER TO PUT BACK IN SO I CAN PUT THE TOP FEEDS BACK IN. KEEP IN MIND THIS IS ON A COSMO PRIMARY FUEL RAIL. I am also not 100% sure that the cosmo primary injectors are top feed or not
Last edited by silverfdturbo6port; 12-28-09 at 09:24 PM.
#2
rotorhead
iTrader: (3)
is it the same as the FC?
http://www.mazdatrix.com/getprice.as...m=13-1580-N326
otherwise post in the 2nd gen forum. Cosmo motors are a lot more common in 2nd gens.
http://www.mazdatrix.com/getprice.as...m=13-1580-N326
otherwise post in the 2nd gen forum. Cosmo motors are a lot more common in 2nd gens.
#5
its hard to explain. say u take out the stock cosmo primary fuel rail and look at the end that the fuel sprays out and compare it to a stock fd. they are a different diameter i think. see there were these collars or inserts in the primary fuel bores on the iron its self that made the two bores smaller than that of a stock fd iron. its the darndest thing i ever seen, the only explanation is the privious owner istalled the injector collars into it like the ones they sell on rx7store.net. here is a pic of what i think it is that i had to pull out of both bores
http://www.rx7store.net/product_p/lim%20spacer.htm
http://www.rx7store.net/product_p/lim%20spacer.htm
Last edited by silverfdturbo6port; 12-29-09 at 10:16 PM.
#6
The aluminum sleeves are from KG parts and are used with aftermarket top feed fuel rails.
$16 shipped for a pair http://kgparts.com/index.php?page=diy
$16 shipped for a pair http://kgparts.com/index.php?page=diy