Cooling panel
#1
Rotary Enthusiast
Thread Starter
iTrader: (12)
Join Date: Jan 2002
Location: tx
Posts: 1,199
Likes: 0
Received 0 Likes
on
0 Posts
Cooling panel
anyone know who makes a good radiator cooling panel? I done some search, and only found one made by carbing. I tried to search, but some post were too old and the pics did not show up.
Thanks Eddie
Thanks Eddie
#3
rotary amuse
iTrader: (12)
I have the carbing cooling panel with a carbon fiber add on piece extended to the radiator (FMIC set up.) i originally thought it to be almost useless without the add on piece, but i am sure the CF part has helped. if i could, i would seal it off on the sides as well.
here's a shot, hope this helps:
EDIT: pettit racing also has one Pettit Cooling Panel
here's a shot, hope this helps:
EDIT: pettit racing also has one Pettit Cooling Panel
Last edited by ZumSpeedRX-7; 11-06-08 at 04:29 PM.
Trending Topics
#8
Registered User
iTrader: (61)
No, it was designed to be a sleeker/sexier version of the pettit one. It was put on the back burner though. The next couple of months I am going to focus on developing a fd sub box for mass production, and a replica of the r-magic headlight kit.
Bryan @ Rx7 Boutique
Bryan @ Rx7 Boutique
Last edited by purerx7; 06-15-09 at 11:58 AM.
#11
Original Gangster/Rotary!
iTrader: (213)
I have one that Kinetik FD3S made a while back, but the install was retarded difficult due to the tight fit around the hood latch. I may modify (read---cut up) the panel to make it bolt in easier. It's a beautiful polished piece too, I've had it laying around for years after a few aborted install attempts.....