I'm working on replacing my clutch in the following days. I'm also installing my Proffec B (original one). I already replace the pilot bearing but having trouble putting in the oil seal. Any tips on how to do this? I already broke one and I was lucky that the local auto part had 2 of them. I'm also having problem getting the input shaft to go all the way in but I think is because the oil seal. Also the throw out bearing, is it suppose to move at all without the clutch installed? I mean like is supposed to? Because I can move it but it doesn't seem to move correctly is just the fork moving but the bearing doesn't move with it or if it does it doesn't move a whole lot. to me it doesn't look right. Any helpful hints will be apreciated.

On the old Proffec B, what is the settingon the back of them for them on the FD's?

Thanks
Rick

PS= I did a search but nothing specific t what I'm looking for, at least not they way I'm searching.

 

never mind on the oil seal I found what I was looking for.

 

still need pointers on tranny installed and boost controller setting

 

bump