The are from the wiring harness that connects the battery and alternator stuff. I believe one to be a oil level sensor clip but Im not sure. And not sure on the other two.
*they are the 3 highlighted in the pic*


thanks

 

Eric for the one on the left try the purge control solenoid infront of the TB

and for the one on the right oil pressure sending unit near the 2nd housing.

im not sure about the one in the middle but there is a little thing (sensor I guess) right infront of the oil pressure sending unit closer toward the front of the car. It probably goes there

 

If you give me the wire colors for the plugs, I might be able to help you out.

 

alright erick...here is what i found.

the one on the left is from the PS (see the two following pictures)





and i can't fid the other two. if you look at my old engine. the sensor thing that i think SurgeMonster is talking about is used by the ecu harness, not the "starter" harness.



soooooo....that wire that you made for the knock sensor should really go to that sensor next to the oil sender unit (an arrow is pointing to it in the last picture). and the wire for the kock sensor should go to where i think you put this PS wire (the connectors look the same for the PS connector and the knock sensor)

i can come by tomorrow and give it another look. i'll be in the shop across the way finishing up my car!

 

THanks Yanni, Mikey, etc..!

Ill swap the clips then and re-stare at the wiring diagrams again for the other 2.

note: And I already have the Oil Pressure sending unit attachment in. Plus the Thermistor is connected and I just dont see any clips not being used in the area.

Hey Mikey, did we connect the 2 harnesses together? I know I didnt yet..

 

Anyone got any good pics of where the 2 Wiring Harnesses connect? (the battery harness side & the UIM harness)
I just dont see a clip for the UIM side to join it to the other harness.

thanks

 

The one on the right looks like the wire leading to the A/C compressor. Trying to remember from when I messed with all the wiring.

 

The wires to the A/C and P/S I connected with ones from the Main Engine Wiring Harness (under the UIM).

 

The one on the far left goes to the power steering. The connector for it is on top of the p.s. pump.


The black one in the middle is for the coolant level sensor. The connector for it comes out of the ecu harness. Look for a black wire coming out near the oil metering pump connector.

The white connector on the right connects to the A/C. The connector for it is on the side of the A\C pump.

 

k, Ill check those out.

Where do the 2 harnesses connect at???