can someone please make this...
#1
Full Member
Thread Starter
Join Date: Feb 2002
Location: pasadena,ca
Posts: 108
Likes: 0
Received 0 Likes
on
0 Posts
can someone please make this...
A handful of folks on this forum have been waiting for someone to make this (or something like it) since 2004(?) when the first set for the FC was made by Pineapple Racing. I've been thru the other posts which all appear to have been dropped. Maybe there just wasn't enough interest but by my math, a buddy and i have been waiting(both project cars are down) for over 3 yrs now for someone to fabricate a suitable alternator relocation bracket. I like the one in the attached picture since it has a separate tensioner pulley and the engineering and craftsmanship of the assy is just beautiful(and plated like the other pulleys and bolts). I just don't have time to go looking for a fabricator with an engine in tow.
i don't know who the setup in the picture belongs to, but I sure would like to contact the fabricator for at least two duplicates. Anyone got any ideas??...
btw, the application we're looking at is for an FD with a 13brew.
i don't know who the setup in the picture belongs to, but I sure would like to contact the fabricator for at least two duplicates. Anyone got any ideas??...
btw, the application we're looking at is for an FD with a 13brew.
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM
rx8volks
Canadian Forum
0
09-01-15 11:02 PM
rx8volks
Canadian Forum
0
09-01-15 10:46 PM