Can someone do me a favor? (measure something)
Thread Starter
Joined: Sep 2003
Posts: 7,252
Likes: 2
From: Spring Hill TN 37174
Can someone do me a favor? (measure something)
I am planning a nifty REW swap into something cool but need some measurements. I need to know the width and the depth of the engine and transmission.
Basically measure
The gap between the strut towers (please on a twin setup)
The length of the engine and tranny as a unit (more importantly where the shifter stems up.
Well thanks in advance, I am off to the standalone sub-forum to figure out how to get the twin setup to work...
Basically measure
The gap between the strut towers (please on a twin setup)
The length of the engine and tranny as a unit (more importantly where the shifter stems up.
Well thanks in advance, I am off to the standalone sub-forum to figure out how to get the twin setup to work...
Can't easily help you with the measurements (hopefully someone has the motor out of the car already) but for engine management go with the PowerFC. Plug in, full programmability, and can fully control the twins in sequential mode. The majority of FD guys run the PFC for good reason - it's a heckuva good computer.
Dale
Dale
Thread Starter
Joined: Sep 2003
Posts: 7,252
Likes: 2
From: Spring Hill TN 37174
Thread
Thread Starter
Forum
Replies
Last Post
Postman09
3rd Generation Specific (1993-2002)
0
Sep 29, 2015 11:23 AM