Can someone do me a favor? (measure something)
 

I am planning a nifty REW swap into something cool but need some measurements. I need to know the width and the depth of the engine and transmission.

Basically measure

The gap between the strut towers (please on a twin setup)
The length of the engine and tranny as a unit (more importantly where the shifter stems up.

Well thanks in advance, I am off to the standalone sub-forum to figure out how to get the twin setup to work...

Can't easily help you with the measurements (hopefully someone has the motor out of the car already) but for engine management go with the PowerFC. Plug in, full programmability, and can fully control the twins in sequential mode. The majority of FD guys run the PFC for good reason - it's a heckuva good computer.

Dale

Trevor, you should PM Dan Chadwick. I'm sure he can help you out. I'm pretty sure he has one out at the shop right now.

Sweet. PM'ing him now.