Broken hose fitting
#1
Full Member
Thread Starter
iTrader: (1)
Join Date: Mar 2010
Location: pa
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
Broken hose fitting
Before anyone yells at me to search, I really can't do that because I have absolutely no clue what this is. It's circled in the picture, on the downpipe side, the front of the motor is towards the right, the rear to the left.
Can anyone tell me what this is? And if I can just swap one with a good fitting from another motor.
Can anyone tell me what this is? And if I can just swap one with a good fitting from another motor.
#2
Senior Member
iTrader: (1)
I would say that is the Turbo Control Actuator, wait until one of the experts posts but thats what it appears to me.
Are your turbos set up in seq or non seq? when you get the block back in that is
If your going non seq then you will end up tearing that off anyway if you are staying seq I am sure you could find one in the parts for sale section
Good Luck
Mike
That picture sucks LOL
Are your turbos set up in seq or non seq? when you get the block back in that is
If your going non seq then you will end up tearing that off anyway if you are staying seq I am sure you could find one in the parts for sale section
Good Luck
Mike
That picture sucks LOL
#3
Full Member
Thread Starter
iTrader: (1)
Join Date: Mar 2010
Location: pa
Posts: 133
Likes: 0
Received 0 Likes
on
0 Posts
hahah its a cell phone picture I'm sorry. I just bought the motor, and its completely stock, so I'd say they are still sequential. I still have the old motor, so i'll just swap it over from that one. Thanks!
Thread
Thread Starter
Forum
Replies
Last Post