boost control location
#1
Junior Member
Thread Starter
Join Date: Mar 2007
Location: Caledon
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
boost control location
Hey is this the location you would put the boost controller in if you have a non-sequential setup? also what other things do you need to do to get the boost to be controlled from there?
Thanks,
Raphael
Thanks,
Raphael
Last edited by raphbo; 06-22-07 at 10:13 AM. Reason: photo
#2
The Power of 1.3
Join Date: Aug 2001
Location: Shrewsbury, Massachusetts
Posts: 2,837
Likes: 0
Received 0 Likes
on
0 Posts
Check out the third gen FAQ: https://www.rx7club.com/3rd-generation-specific-1993-2002-16/faq-3rd-gen-other-useful-links-68640/
Specifically the section on the non-seq setup:http://www.fd3s.net/non-sequential.html
Specifically the section on the non-seq setup:http://www.fd3s.net/non-sequential.html
#3
Junior Member
Thread Starter
Join Date: Mar 2007
Location: Caledon
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
I installed the boost controller.....uh...???
I installed the boost controller as in the photo, do I need to open the boost controller before I start the engine? What else do I need to do? I capped off the bottom of the wastegate actuator valve. I started it while it was shut as such and it sounded really bad, I think something must be wrong, not sure what it is. any help would be really great.
Thanks,
Raph
Thanks,
Raph
#5
Junior Member
Thread Starter
Join Date: Mar 2007
Location: Caledon
Posts: 20
Likes: 0
Received 0 Likes
on
0 Posts
Sure if I had one, I am just asking about in my current setup with the manual boost T do I need to keep it open while the car is first started up? if so how many revolutions do I turn it?
Thread
Thread Starter
Forum
Replies
Last Post
Skeese
Adaptronic Engine Mgmt - AUS
65
03-28-17 03:30 PM
stickmantijuana
MoTeC
5
09-10-15 07:58 PM