Can anyone send me a link for english instructions for the Blitz SBC i-D boost controller.
I've tried searching and found stuff but the links don't work anymore.

thanks for any help

 

http://www.team3s.com/Blitz%20SBC%20i-D%20manual.pdf

 

I dont have the instructions but here is what I can remember of the install (almost 2 years ago).


You have to run a line from manifold to the interior silver unit - connect to the black pigtail coming out of unit.

Then run a line from manifold to black engine bay unit IN. Run line from OUT to top of wastegate.

I dont even remember how many electrical connections there were so I cant help you there...

 

thanks!!

 

Cool I just got one of these, also with the speed meter. Ther were no instructions with eather.

Any one have the instuctions for the speed meter. It says how they work together on those instuctions. But none on how to hook up the speed meter.

I beleave it's just a vehicle speed wire, power, and ground?

 

Yes the only 3 wires I remember are those. The units actually talk to each other by IR which is the only think I dislike about the setup (but if you mount them together they work fine). The wire you hook into on the ecu speed wire which is listed in the manual.

I posted a thread a while back but upon reading it it may not be as clear as I wanted without the "wrong" instructions.

https://www.rx7club.com/showthread.p...tz+power+meter

Shawn

 

How did you like using the two together? Thanks for that thread.

 

Its great! The system does a great job. I run 10psi up to 30mph and then go up to 12psi to 60 and 14psi above that.


Shawn