Best way to connect wideband to datalogit?
#1
No Paypal Accepted!
Thread Starter
Best way to connect wideband to datalogit?
I know the info is out there but I can't find it. Maybe I'm not typing in the right search phrases? I know this isn't really the right section but few people seem to visit the PFC section.
Also dont flame me for not checking the FC Yahoo group, apparently its against NZ law to return a goddamn email . which means I don't have access.
I have the PLX M200 and Im trying to connect it to the FC datalogit.
My questions are these:
Is it best to just wire up the white wire and leave the grey one off? Which output do I connect it to?
Once connected what the hell do I have to type in to get it to read properly, Ive read in my searching it needs a math equation .
Thanks
Also dont flame me for not checking the FC Yahoo group, apparently its against NZ law to return a goddamn email . which means I don't have access.
I have the PLX M200 and Im trying to connect it to the FC datalogit.
My questions are these:
Is it best to just wire up the white wire and leave the grey one off? Which output do I connect it to?
Once connected what the hell do I have to type in to get it to read properly, Ive read in my searching it needs a math equation .
Thanks
#2
Senior Member
iTrader: (2)
Join Date: Feb 2003
Location: Kingston Ontario
Posts: 719
Likes: 0
Received 0 Likes
on
0 Posts
If I remeber to my dataloging days connect the 5 volt to one and then the ground from the o2 sensor to another 5 volt lead. Then select Delta X Values and that will do it for you. You could otherwise put the ground to chassis ground. And then use the ground off the datalogit. But it tends to lower the values a little bit.
Thread
Thread Starter
Forum
Replies
Last Post
Captain Hook
2nd Generation Specific (1986-1992)
13
10-04-15 06:35 PM
FC3S Timmy
2nd Generation Specific (1986-1992)
16
10-03-15 01:08 AM