I picked up a couple WBO2 units,one has a square gauge which I installed and works fine.
I have had it in my Car for ever since I can remember.
Now,I got a LA1 Round faced Gauge and it has the connector to interface with the WBO2 but there is also 4 wires coming out of it and I can't find any info on what the wires are for.
Is there anyone that can tell me what they are for and where they would go on the WBO2 Control box?
Thanks Guys.
STYX.

 

Jesus was just a guy..bump!

 

We called her Ilene.She had one leg shorter than the other.
... BUMP..(tilt)..

 

sound of armless man clapping BUMP!

 

Tech Edge should be able to tell you, if this page doesn't answer your question. LA1 User's Guide (Tech Edge)

 

That's the problem.,,I emailed Tech edge and not a single reply.I even posted in the Aus Section and that section is "deserted".
The connector is for hooking the gauge up..no problem.
The 4 wires are for rpm,etc to make the gauge see other sensors and I need to know which wire goes to where.
orange,black,blue and green.

 

okay...so I spent about 5 minutes reading and came up with this.
Here it explains the 4 wires:
LA1 Technical Information (Tech Edge)
You have a 0-5v input of your choice using (P1=ADC + P2=Ground).
For Rpm its (P6=RPM).
Here is the kicker, you have to remove the screw on the side of the gauge and pull the grey cover off. From there you can see the P1+P2+P6 contact points and verify what color is which.
Now once you figure that out and wire everything up then you have to configure/tell the gauge what its reading (RMP, Speed, etc) using the utility on this page:
WButil (DConf) - Configuration and Utility Software for WBo2 (Tech Edge)

Thats just my guess lol.

 

Son of a B****!!..
I guess I deserve "the bird giving me The Bird!"
Thanks man.totally appreciated!