anyone dynoed ur car with pettit ECU?
Thread Starter
Rotary Enthusiast
Joined: Nov 2001
Posts: 1,483
Likes: 0
From: US
anyone dynoed ur car with pettit ECU?
List your mods and A/F ratio and dyno sheet if u have it. im thinkin about getting one and i need some information!!
thank you.
thank you.
Last edited by FstFD3SPOWER; Sep 26, 2002 at 04:12 PM.
Full Member
Joined: Jul 2002
Posts: 54
Likes: 0
From: Lakewood, NJ
Dynoed in May of this year with the Pettit standard ECU upgrade:
Other mods were
M2 intake
M2 large IC
UR full pulley kit
DP
Greddy Sp
9.5lb flywheel
Have all reliability mods as well. 1st run netted me 331RWHP and 284 TQ. Temp was about 60 degrees.
I was running 100 octane and boost was somewhere between 14-15psi. Not sure exactly of A/F ratios but my J&S sensor indicated full rich with no blips on the knock detector.
FWIW, my car has 40K miles on original engine turbos. This same setup led me to a 12.4 @113mph on street tires.
Other mods were
M2 intake
M2 large IC
UR full pulley kit
DP
Greddy Sp
9.5lb flywheel
Have all reliability mods as well. 1st run netted me 331RWHP and 284 TQ. Temp was about 60 degrees.
I was running 100 octane and boost was somewhere between 14-15psi. Not sure exactly of A/F ratios but my J&S sensor indicated full rich with no blips on the knock detector.
FWIW, my car has 40K miles on original engine turbos. This same setup led me to a 12.4 @113mph on street tires.
Thread
Thread Starter
Forum
Replies
Last Post