any advise you want to give?
#1
Junior Member
Thread Starter
Join Date: Apr 2002
Location: Oklahoma
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
any advise you want to give?
alright...my money pit (FD) is almost done for a while! after new turbos...new lots of stuff...and, right now as we speak, a new clutch and lightened flywheel, my car is almost good for a while. but i now have my:
1) yellow konis
2) Racing Beat springs
3) M2's trailing arms and toe links
i am going to finally get around to putting these on this week. anybody have any advice to make this install as fast and smooth as possible?
thanks,
mikey
1) yellow konis
2) Racing Beat springs
3) M2's trailing arms and toe links
i am going to finally get around to putting these on this week. anybody have any advice to make this install as fast and smooth as possible?
thanks,
mikey
#2
Z06 powered FD
Join Date: Mar 2001
Location: Dallas, Texas
Posts: 1,883
Likes: 0
Received 0 Likes
on
0 Posts
For the training arms, take out the bolt on the lower control arm that screws into the t/arm first. If not the other end will just turn. Haven't done toe links yet.
Rob Robinette has a good write up on spring/strut installs.
http://www.rx7.org/Robinette/shocks.htm
Be sure to get an alignment afterwards.
Rob Robinette has a good write up on spring/strut installs.
http://www.rx7.org/Robinette/shocks.htm
Be sure to get an alignment afterwards.
Thread
Thread Starter
Forum
Replies
Last Post
eplusz
General Rotary Tech Support
15
10-07-15 04:04 PM
joel(PA)
Race Car Tech
0
10-01-15 10:25 AM