Another damn Stumble problem...
#1
Senior Member
Thread Starter
Join Date: Jul 2006
Location: Stow, Ohio
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
Another damn Stumble problem...
First, it ran fine but kicked into limp mode because of the MOP. I replaced the MOP, and now it's not givng me a code anymore, hurray!! but it's still doing the same ****. before, it would rev up fine unti,l the code came up. now as soon as the secondary butterflies open, it backfires and falls on it's face. i dont understand..
#4
Senior Member
Thread Starter
Join Date: Jul 2006
Location: Stow, Ohio
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
bump. i did do the fuel pump rewire.. i think, if i got a wire wrong somehow would it allow the car to run but not switch over to 12v? it seems it can only work 1 way
#6
Senior Member
Thread Starter
Join Date: Jul 2006
Location: Stow, Ohio
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
i guess i'll check tps voltage in comparison to butterfly position to se if its butterfly position thats cuasing the stumble or somethign associated with tps voltage readin. like if 2ndaries kick in at a certain tps voltage or something similar, so i can narrow it down and go from there...
#7
The nonspatial continuum
iTrader: (4)
Join Date: Jan 2006
Location: Seattle
Posts: 386
Likes: 0
Received 0 Likes
on
0 Posts
I would say its something around or close to the MOP, because you said it ran fine until you replaced it. I would double check everything just to be sure something wasnt overlooked. Also was the comp reset or the code cleared after you replaced it? If not it may think something up, when infact its fine.
Just a htought...
Just a htought...
Trending Topics
#9
Senior Member
Thread Starter
Join Date: Jul 2006
Location: Stow, Ohio
Posts: 582
Likes: 0
Received 0 Likes
on
0 Posts
no it ran fine for the 30 seconds before the CEL cmae on before I fixed it. i was getting a code 27 but before the code kicked in it ran fine. now the codes gone cause i put in a new MOP but it's still doing it.
Thread
Thread Starter
Forum
Replies
Last Post
rgordon1979
3rd Generation Specific (1993-2002)
40
03-15-22 12:04 PM