Air-Water intercooler water lines routing
#1
Air-Water intercooler water lines routing
I wanted to make an air-to water IC with a water/ice tank in the trunk.
In my class, I am not allowed to modify any body panel or structural member, incl. the firwall.
What existing opening could I use to run - say - 2x1" diam. or a bit less water hoses?
I am using already the opening on the passenger side to run a battery cable and other instrument wires. There is no more room there.
There is a similar opening on the passenger side under the hood but no adjacent opening I could see to the cabin.
Would the A/C lines through the firewall be large enough? I still have the A/C and find it difficult to judge if the holes are large enough.
Is there any room I could run and secure such lines perhaps through the transmission/gearshift tunnel?
Any other suggestions?
Thanks,
Sandro
In my class, I am not allowed to modify any body panel or structural member, incl. the firwall.
What existing opening could I use to run - say - 2x1" diam. or a bit less water hoses?
I am using already the opening on the passenger side to run a battery cable and other instrument wires. There is no more room there.
There is a similar opening on the passenger side under the hood but no adjacent opening I could see to the cabin.
Would the A/C lines through the firewall be large enough? I still have the A/C and find it difficult to judge if the holes are large enough.
Is there any room I could run and secure such lines perhaps through the transmission/gearshift tunnel?
Any other suggestions?
Thanks,
Sandro
Thread
Thread Starter
Forum
Replies
Last Post
rotor_veux
2nd Generation Specific (1986-1992)
7
08-31-15 07:49 PM