99 twin turbos- compressor catching on housing (rubbing)
#1
99 twin turbos- compressor catching on housing (rubbing)
I am working on a set of 99 twins and when free hand spinning the turbine, the fins contact the housing. There is almost no shaft play, and its like there is a very small clearance between the housing and fins that when spun up allows the turbine to "float" and not impact.
Just want to make sure these are ok before they go back in a car.
Just want to make sure these are ok before they go back in a car.
Thread
Thread Starter
Forum
Replies
Last Post
ray green
1st Gen General Discussion
2
09-02-15 06:35 AM