Hey i have one and dont know which wires go to A, B, and C. I searched and couldn't find anything so someone please help me out thanks.

 

...

 

I assume it looks like the one on this page?
http://www.horsepowerfreaks.com/sale...ronics/Sensors
I know there was several threads in the PFC forum about this, but the search seems to be FUBAR right now. Sorry.

 

Says in the Haltech manual ...

 

Google worked for me

http://hhscott.com/93tmv/3-bar_map.htm

 

what the hell is up with the search and I can't even start a thread

 

im a bit of a noob. what is the limit of the stock sensor?

 

Here you go ...

 

Based on observing my data logs, mine would not read pressures over 1.15 kg/cm^2, which is about 16.3 psi. I graphed my boost pressure over some time span in which the actual boost pressure exceeded the limit, and the reading just stays at 1.15 until you drop back down under that pressure.

-Max

 

thanks guys

 

I have one sitting around also...I'd like to install it but do I need a total re-tune on my PFC or is it only some settings?

 

Your PFC needs to be set with a datalogit for the 3 bar map sensor to work right

 

right, I know that...but do you have to change the fuel map at all or do you just have to change a setting?

 

Yes, you will have to change a number of things.....at minumum.......

1. You will need to switch from Normal to Option 1 and redo the offset.

2. You will have to change your pressure resolution along the Y axis to reflect the change in pressure...

3. You will need to remap any cells affected by the changes in #2 above.

 

good thread....I was wondering about this for a while. I though Max has a page about this in his personal site. But, I couldn't fine it.