mmonaco

I have 2 questions about intercoolers.
1. has anyone tried to use a 4row intercooler from a supra on a 7. will it fit on there.
2. I am planing on going single in a little bit, that is turbo, but i dont wanna buy a little intercooler for my stock twins and then sell that one to get a 3/4 row intercooler for the single. so i can i run a 3/4 row on stock twins. what would be the problem. my guess is presure loss.
thanks Marc

jspecracer7

I've seen the Big Greddy IC run with stock twins. They say pressure drop, but none that I've seen.

I run a big Feed FMIC on the stock twins. 4" thick core. No problems on my end.

ttpowerd

Van, do you run with the feed v-mount? (your going to love this) Can I see some pics of your setup?

jspecracer7

What's up Bryan?

I have only seen the knightSports V-Mount and the Panspeed V-Mount, not the Feed V-Mount. I just run a Feed FMIC with STOCK radiator....but with my PFC and datalogit, my fans kick on 20 degrees sooner. And since I don't have A/C, I can turn my fans on with a couple of clicks. I have actually gotten my water temps to go down so low that they "close" the thermostat.

I'm still waiting for my radiator from RX-7 Store. I've been waiting a long time

inukai

Hi

Jspecracer gave you tips.

mmonaco, I'm wondering 4row IC from Supra?
It's not a stock one, because 4row.
It's aftermarket one.
The piping sets are quite different.
If you can buy them at the very low cost,
labor cost for fitting can be very high.

mmonaco

ya its a greddy 4 row i was talking about. alot of supra guys use it on there single and love it. so ill be alright going with the greddy 3row on stock
Thanks Marc.

jspecracer7

Nothing wrong with having a thick i.e. 4 row IC. Just be sure that it's not LONG too. Then you'll have big pressure drops.

PVerdieck

jspec, what radiator have you been waiting on?

I ordered a fluidyne, called, massive back ordered, switched to a koyo, then changed my mind and sent it back to get the new M2...

jspecracer7

I ordered the Koyo. I'm not going to mention how long I've been waiting...but it's been A LONG TIME. If you want to know...PM me and I'll spill the beans, but I'd prefer not to bring Jason's name in this.

mmonaco

i tried to find some numers on te sizes of these turbos but can find any. It looks like they dont want you to know. IS there any good sites for dimension.
Thanks Marc

PVerdieck

I'm fine as is. The only thing I am dreading is all the labor! I have heard it is easier to do it from the bottom...