3rd Generation Specific (1993-2002) 1993-2002 Discussion including performance modifications and Technical Support Sections.
Sponsored by:

1994 RX7 Body Electrical Troubleshooting Manual

Thread Tools
 
Search this Thread
 
Old Oct 2, 2004 | 06:31 PM
  #1  
tom_marsland's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 60
Likes: 0
From: Ladson, SC
Question 1994 RX7 Body Electrical Troubleshooting Manual

Anyone know where I can get it online? I did a search to no avail, but my factory manual says to look there to troubleshoot the starter wiring harness.

Thanks
Reply
Old Oct 2, 2004 | 06:37 PM
  #2  
mad_7tist's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 1,899
Likes: 0
From: tampa
whats the problem? you should have power on the big terminal of the starter and batt voltage on the small black connector when you crank it. you can disconnect the batt cable and ohm the ground wire. visualy inspect the wires. so do you have power on the black connector when you crank?
Reply
Old Oct 2, 2004 | 06:52 PM
  #3  
tom_marsland's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 60
Likes: 0
From: Ladson, SC
Well, I'm going to do a double-check of it again when I get more than two hands, but when I did it by myself, I got nothing on the small terminal when I cranked.
Reply
Old Oct 2, 2004 | 07:05 PM
  #4  
mad_7tist's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 1,899
Likes: 0
From: tampa
is it a manual? check the neutral safety switch
Reply
Old Oct 2, 2004 | 07:10 PM
  #5  
tom_marsland's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 60
Likes: 0
From: Ladson, SC
Where/ how do I check that? The car was in neutral, and I had the clutch depressed just to make sure when i checked voltage.
Reply
Old Oct 2, 2004 | 07:15 PM
  #6  
Dwood432's Avatar
Full Member
Tenured Member 10 Years
 
Joined: Jan 2003
Posts: 130
Likes: 0
From: Detroit area
I don't know if you already looked at this but


http://www.iluvmyrx7.com/3rdgen/manuals/93%20manual/(G)engine_electrical_systems.pdf


Copy and paste it

I hope it helps

Last edited by Dwood432; Oct 2, 2004 at 07:17 PM.
Reply
Old Oct 2, 2004 | 07:16 PM
  #7  
mad_7tist's Avatar
Rotary Freak
Tenured Member 05 Years
 
Joined: Jan 2004
Posts: 1,899
Likes: 0
From: tampa
chk your pm's
Reply
Old Oct 2, 2004 | 07:29 PM
  #8  
tom_marsland's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 60
Likes: 0
From: Ladson, SC
got yours, check yours.
Reply
Old Oct 2, 2004 | 09:36 PM
  #9  
tom_marsland's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 60
Likes: 0
From: Ladson, SC
Okay, so clutch switch is good, but with key in start, small terminal @ starter doesn't get voltage half the time, (intermittent fault). Could either be wiring or ignition switch then.. How do I check that? And I repeat my 1st question, anyone know a place online to see the RX7 Electrical Troubleshooting manual
Reply
Old Oct 3, 2004 | 03:57 PM
  #10  
tom_marsland's Avatar
Thread Starter
Full Member
Tenured Member 05 Years
 
Joined: Sep 2004
Posts: 60
Likes: 0
From: Ladson, SC
bump for the night. Any helpful hints anyone?
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
Th0m4s
Build Threads
25
Feb 26, 2019 02:04 AM
BNR34RB26DETT
Build Threads
42
Feb 28, 2018 11:27 AM
82streetracer
1st Generation Specific (1979-1985)
7
Aug 23, 2015 09:28 AM




All times are GMT -5. The time now is 07:51 AM.