1600cc, can i make them work with stock ecu
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Jun 2003
Location: Central Florida
Posts: 1,619
Likes: 0
Received 0 Likes
on
0 Posts
1600cc, can i make them work with stock ecu
Hey guys, I need to drive my car around for a few guys *without being on boost* is there any sort or resistance or anything i can do to make my 1600cc injectors work like the stock 850s?
Thanks
matt
Thanks
matt
#4
Banned. I got OWNED!!!
Thread Starter
Join Date: Jun 2003
Location: Central Florida
Posts: 1,619
Likes: 0
Received 0 Likes
on
0 Posts
basically what happens is, car starts idles.. to rev it you have to be really soft on it otherwise it stalls like it hits fuel cut or the secondaries are trying to kick in or somthing. Replaced injectors thinking that might be it, changed ignition packs, engine harness.. Im confused..
#5
Lives on the Forum
Join Date: Dec 2001
Location: San Lorenzo, California
Posts: 14,716
Likes: 0
Received 8 Likes
on
8 Posts
Well, once you hit the primary injector duty cycle threshold (around 2700-3000 rpm or so), the secondaries will kick in, dumping twice as much fuel as they are supposed to. So, if you can keep it below 2700rpm, you should be fine.
Why don't you have a PFC or something in there?
Why don't you have a PFC or something in there?
#6
Banned. I got OWNED!!!
Thread Starter
Join Date: Jun 2003
Location: Central Florida
Posts: 1,619
Likes: 0
Received 0 Likes
on
0 Posts
i got a pfc.. does same thing.. i think maybe my secondary wire connections are screwed up maybe..basically I can put no load on the car and if i stomp gas it stalls out but if i feather it very soft and slow i can rev it.. cant drive it all at.. It happened when i was going down the road.. went to pass somone and it stalled.. engine compression is perfect, replaced coilpacks, engine harness, 1600cc injectors.. but not wires..
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
07-01-23 04:40 PM