I have done the"por mans non seq" conversion.

Dose it mather if i use wastegate control or turbo precontrol to adjust the boost with

 

I cant get it to boost more than 0.55 kg!!

anyone??

 

What would that be in lbs or bar? It could be a leak or just missing wastegate pills converting that number to lbs. might help us more.

 

.55 kg/cm^2 is a little less than 8psi, right around wastegate spring pressure.

you control boost with the wastegate actuator. A typical setup is to run a manual boost controller in-line with the pressure source for the wastegate. Then you cap the other nipple on the actuator and remove the wastegate/precontrol solenoid assembly completely.

IMO, and this is speculation here: it should still be possible to control boost with the PFC if you left the wastegate solenoid lumbing hooked up with the restrictor pill removed. Then turn off sequential turbo control in the PFC and set your boost. Set the "primary" and "secondary" boost values to the same level with the same duty value for both and it should control boost decently if you fiddle with the duty settings some.

 

Thank you! this is what i was looking for. Thanx!!