Testrun

So I searched and couldn't find out where the 2 supplied washers go. Everything else seems pretty self explanatory. I assume the are for the banjo bolt?
You guys use any kind of thread tape or locktite on any of the threads? I know it is under pressure unlike the sump (obviously) and I dont want any leaks (obviously)

I want to run my temp sensor in this area to see what my cooler is doing, but of course I dont want to mess it up and have leaks everywhere. I wouldn't mind running a larger filter hence why I figured this may be a good mod.

Banjo bolt off then 2 10mm nuts for pedestal. Install o-rings. Make sure studs are lined up, tighten nuts to around 8lbs. Attach banjo bolt and filter and that's it? Maybe I will see what the washers are for when I remove banjo? I dont like getting into job without knowing details and couldn't find a diagram.
So again as of now I have no idea about washers and wether or not to use tape or locktite. Sorry for the questions. I am learning as I go. I never did this before, just like I never did a fuel pump before. The pump was easy and I hope this is too.

Thanks in advance for any help!!

Terry

Testrun

K disregard. I found my instructions
I dont have the "supplied" m6 nuts though

Midsnow

Should of come in a little bag with the rest of the hardware.
I just did my Sakebomb oil pedestal as well.
You might be able to reuse the nuts from the old pedestal, should be the same size and thread pitch.

Testrun

Thanks Mid. I was hoping to hear that (reuse factory bolts that is). Yes everything else is in the little sealed section of the bag except those.