Bending an oil hard line
#1
Rotary Enthusiast
Thread Starter
Bending an oil hard line
So with the addition of the new oil pedestal the hardline is sitting right on the neck of the oil dipstick tube.. I feel like a dipstick because I just noticed it tonight. .... It does state the line may need to be bent a bit. Is there a good way to bend this line to give a couple mm clearance without removing it? I didn't try by hand, but I am assuming she would be rather difficult. I would like to start her up tomorrow and go get my senior installed fir the wideband, but obviously I want to make sure it will be ok.
Thread
Thread Starter
Forum
Replies
Last Post
JAPSPECGTUs
2nd Generation Specific (1986-1992)
6
09-22-04 05:59 PM
WooshJr
3rd Generation Specific (1993-2002)
2
02-22-02 04:30 PM