Rywire harness/Liquid Pressure Sensors Install and TPS calibration
#1
Full Member
Thread Starter
Rywire harness/Liquid Pressure Sensors Install and TPS calibration
Yup... I ended up replacing the whole harness and ECU (even though I was just going to do a small upgrade). The amount of jacked up crap this car had made me just replace most of the engine component and management. Oh this video you will see how I installed the Rywire 's Plug and Play (PnP) harness for the rx-7 FD. I've also decided to route everything (all sensors) back to the computer since the Modular PnP Adaptronic have a lot of safety features that the Power FC didn't offer. Liquid pressure sensors (for Oil and Fuel) were installed and calibrated in the ECU as well. In addition of the TPS calibration and other small stuff that have to be done on that first start up!
The following 2 users liked this post by WestDc5:
DaleClark (11-01-21),
twinturborx7pete (11-01-21)
Thread
Thread Starter
Forum
Replies
Last Post