Removing water pump stud
#1
Rotary Enthusiast
Thread Starter
Removing water pump stud
Just want to check in before I break something.
Installing an idler pulley and as you can see the stud is barely long enough to fit the supplied nut..
Would a stud extractor work best here? I can't really fit 2 nuts on it to remove it, but I don't want to strip the stud... not get it out, and then really have issues.
Any ideas welcome.
Installing an idler pulley and as you can see the stud is barely long enough to fit the supplied nut..
Would a stud extractor work best here? I can't really fit 2 nuts on it to remove it, but I don't want to strip the stud... not get it out, and then really have issues.
Any ideas welcome.
#2
Rotary Enthusiast
Thread Starter
Disregard this post. Mods can delete if they want... just paranoid. I will use a vise grip and if that fails a stud remover...
#4
Rotary Enthusiast
Thread Starter
Thx. It came out super easy with just a damn vise grip.
Thread
Thread Starter
Forum
Replies
Last Post