Exhaust Too Loud, Suggestions?
#26
Rotary Enthusiast
iTrader: (1)
A typical exhaust shop resonator will be filled with fiberglass insulation. Rotary engine exhaust is so hot that it will melt this insulation immediately. A good rotary resonator will be filled with steel wool, or a similar substance. Your "new" resonator is likley burned out.
#27
Original Gangster/Rotary!
iTrader: (213)
I recommend you swap to this bad boy first, plus you'll be supporting a forum vendor
(first on the list)
Downpipes & Midpipes (93+ RX-7)
(first on the list)
Downpipes & Midpipes (93+ RX-7)
#28
FD Daily
iTrader: (26)
I recommend you swap to this bad boy first, plus you'll be supporting a forum vendor
(first on the list)
Downpipes & Midpipes (93+ RX-7)
(first on the list)
Downpipes & Midpipes (93+ RX-7)
That midpipe made even my PFS catback quiet and livable.
The following users liked this post:
GoodfellaFD3S (10-13-17)
#30
JDM Junkie
iTrader: (5)
It sounds a bit quieter with those bolt in silencers, but the main thing seems to be a reduction in the persistent deep drone which regardless of decibels should be perceived to be a significant reduction to the noise level.
My question to those far more knowledgeable than I - should one be concerned about the addition of such a restriction to the exhaust with regards to their ecu tune?
My question to those far more knowledgeable than I - should one be concerned about the addition of such a restriction to the exhaust with regards to their ecu tune?
#33
Full Member
Thread Starter
iTrader: (1)
Join Date: Sep 2016
Location: California
Posts: 78
Likes: 0
Received 0 Likes
on
0 Posts
Still breaking in the new engine, so I can't tell any difference at this point... Rev is limited to 4k... Noise is definitely quieter, so old ladies in my hood should be little happier.
#34
I
iTrader: (6)
I was debating toning my exhaust down a hair as well. It was pretty decent with working sequential twins(pretty quiet with the TCA closed)
7670 EFR, 3" downpipe, rx7store resonated midpipe, and RB cat back. but seems quite a bit louder with the new turbo setup.
any ideas? maybe the resonated midpipe burned out? cant remember what brand muffler is used?
7670 EFR, 3" downpipe, rx7store resonated midpipe, and RB cat back. but seems quite a bit louder with the new turbo setup.
any ideas? maybe the resonated midpipe burned out? cant remember what brand muffler is used?