Sputtering

 
Thread Tools
 
Search this Thread
 
Old 07-23-01, 02:16 PM
  #1  
Junior Member

Thread Starter
 
TNIGHT's Avatar
 
Join Date: Jul 2001
Location: Wisconsin
Posts: 17
Likes: 0
Received 0 Likes on 0 Posts
Sputtering

I have a 93 base. upon purchase it ran fairly well with exception of no 2nd turbo action .Anyway I go in replace and tie the vac. lines get everything back together. builds up speed as long as I don't stab the gas pedal which is when it bucks and sputters.

Any help is appreciated!!!!!!!!!!!1
TNIGHT is offline  
Old 07-23-01, 09:01 PM
  #2  
Full Member

 
nrolfes1's Avatar
 
Join Date: Apr 2001
Location: Metro Detroit, MI
Posts: 156
Likes: 0
Received 1 Like on 1 Post
I had this problem, it was a weak engine ground. I reinforced the ground by putting a big ol fat wire from the engine to the chassis and it fixed the problem immediately.
nrolfes1 is offline  
Old 07-24-01, 12:11 AM
  #3  
Senior Member

 
Bucrx7's Avatar
 
Join Date: Mar 2001
Location: Massachusetts
Posts: 724
Likes: 0
Received 0 Likes on 0 Posts
Check your plugs and your wires. If you sputters when you gun it then you'll most likely need new plugs.


Tony S.
Bucrx7 is offline  
Old 08-05-01, 10:23 PM
  #4  
Junior Member

Thread Starter
 
TNIGHT's Avatar
 
Join Date: Jul 2001
Location: Wisconsin
Posts: 17
Likes: 0
Received 0 Likes on 0 Posts
Plugs and wires are new ground is good I tied the vacuum lines the hole silicon replacement deal and I have been in twice and nothing appears pinched but I can hear a surge when I release the throttle not the same as a bov release
TNIGHT is offline  
 
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
PinkRacer
2nd Generation Specific (1986-1992)
43
10-01-15 09:13 AM
sherff
Adaptronic Engine Mgmt - AUS
5
09-12-15 12:22 PM
RotaryBobby
1st Generation Specific (1979-1985)
1
09-10-15 01:33 PM
rx7shirley
2nd Generation Specific (1986-1992)
6
09-02-15 02:11 PM
PhillyFC
General Rotary Tech Support
9
08-21-15 06:36 PM



Quick Reply: Sputtering



All times are GMT -5. The time now is 08:36 PM.