Would you buy a Carbon Fiber T2 or Duckbill spoiler?
02-28-12, 02:23 PM
#51
as for the weight of the carbon hood, i would think there could be a small amount to save if any at all. i have only had my fc for a few years but i have yet to see a company that makes a true full carbon hood. they are all frp.
i have been around supra's for over 10 years and have read a lot on this subject.
the seibon hoods (frp or carbon look) are only 3 pounds lighter than the stock hood
the top secret carbon hood ( 100% carbon with no structure) is just 9 pounds lighter than stock
also the seibon "carbon" fenders are only 1 pound lighter than stock
so until someone weighs there stock alum hood and a carbon hood, your guess is as good as mine
i have been around supra's for over 10 years and have read a lot on this subject.
the seibon hoods (frp or carbon look) are only 3 pounds lighter than the stock hood
the top secret carbon hood ( 100% carbon with no structure) is just 9 pounds lighter than stock
also the seibon "carbon" fenders are only 1 pound lighter than stock
so until someone weighs there stock alum hood and a carbon hood, your guess is as good as mine
Last edited by rusty FC; 02-28-12 at 02:25 PM.
02-28-12, 02:54 PM
#52
I think AWR used to make a CF race hood for the FC RX-7 that was 7lbs or so.
Just a skin, no provisions for pop up lights/hinge/mounting/fitment.
I have to essentially slam my CF hood for the stock latch to grab because it's so much lighter than my original stock Vert Aluminum hood.
Probably just need to align the latch.
The 4lbs or so difference over the whole area of the hood between the two should not cause what you are describing.
Just a skin, no provisions for pop up lights/hinge/mounting/fitment.
I have to essentially slam my CF hood for the stock latch to grab because it's so much lighter than my original stock Vert Aluminum hood.
Probably just need to align the latch.
The 4lbs or so difference over the whole area of the hood between the two should not cause what you are describing.
02-28-12, 07:04 PM
#53
Don't hate my V8
iTrader: (4)
Join Date: Mar 2006
Location: Cornfield, Indiana
Posts: 1,129
Likes: 0
Received 0 Likes
on
0 Posts
i thought the difference would be minimal as well (i've never had a CF FC hood to compare but have lifted CF hoods of similar size) as well as the body on my FC is so rough its not worth spending the money on a CF hood ATM, id rather just get more air out of the engine bay...
02-29-12, 01:48 AM
#54
Like a G6
iTrader: (1)
Join Date: Dec 2007
Location: In the Dutch Mountains
Posts: 713
Likes: 0
Received 0 Likes
on
0 Posts
Aside from perhaps your disturbing comment about your Mom riding a whale (certainly trumps any Tijuana stories),
you couldn't be more wrong.
As I commented in the post above yours, I have to essentially slam my CF hood for the stock latch to grab because it's so much lighter than my original stock Vert Aluminum hood.
Also: What company/engineer produced your hood?
Riz.
03-27-12, 12:40 AM
#56
Original Gangster/Rotary!
iTrader: (213)
Hate to break it to ya Smiley, but threads like this are against club rules.
If you want to move forward with a Group Buy, sign up as a GB Vendor. The cost is only $75 per GB good for 3 months. There are stickies at the top of the classifieds section.
I can merge this thread into a a future GB thread if you decide to go that route.
If you want to move forward with a Group Buy, sign up as a GB Vendor. The cost is only $75 per GB good for 3 months. There are stickies at the top of the classifieds section.
I can merge this thread into a a future GB thread if you decide to go that route.
Thread
Thread Starter
Forum
Replies
Last Post
