WOOOHOOO I got the rx7 Running!!!
Hey Guys!
I just wanted to let everyone know that this morning I officially got the 7 rolling, and back to my house!!!!
I ended up just replacing the starter, and BAM it works!!!!
But I have another problem.... And I hope maybe you guys could just point me in the right direction.
So.... I got to drive it around, and it runs really good at low RPM's. Actually, I am able to rev it really high, but I cant push the petal all the way down. I can only gradually push it down to get that high. And when driving, I have to do the same thing. Its like it does not like the petal going further than a little bit to run. It almost seems like it wants to stall when I mash the gas a little bit.
Any ideas? At least to point me in the direction that I need to do?
I just wanted to let everyone know that this morning I officially got the 7 rolling, and back to my house!!!!
I ended up just replacing the starter, and BAM it works!!!!
But I have another problem.... And I hope maybe you guys could just point me in the right direction.
So.... I got to drive it around, and it runs really good at low RPM's. Actually, I am able to rev it really high, but I cant push the petal all the way down. I can only gradually push it down to get that high. And when driving, I have to do the same thing. Its like it does not like the petal going further than a little bit to run. It almost seems like it wants to stall when I mash the gas a little bit.
Any ideas? At least to point me in the direction that I need to do?
the TPS is the Throttle Positioning Sensor, check the FSM (Factory Service Manual) for specifics on that. (It's free, and on here, check the FAQ's. The ECU is located where the passenger puts their foot, you have to pull the carpet back to get to it.
Thread
Thread Starter
Forum
Replies
Last Post
thecody59
1st Generation Specific (1979-1985)
40
Aug 23, 2015 06:41 PM
ncds_fc
New Member RX-7 Technical
1
Aug 15, 2015 10:06 AM
KAL797
Test Area 51
0
Aug 11, 2015 03:47 PM



