wont run
Senior Member
Joined: Sep 2003
Posts: 355
Likes: 0
From: Berthier, Quebec
stuck open or REALLY dirty injectors
remove them, and get them cleaned and/or rebuilt
also, do not forget when this is done to pour a little bit of oil in each housing to rebuild the compression, turn the engine 2-3 times by hand and dry the plugs before trying to start it
you might to check the engine's compression as well, to be sure of the engine's internals condition
if it was seriously flooded, I would highly recommend to change the oil since the fuel may has contaminated your oil.
if it's a spark problem, check if your high tension leads receive power. if yes, change plugs, if no, mostly it's gonna be a bad ground, faulty coils, or defective CAS
if its air problem, most of the time it is a defective AFM
that would be a good beginning.
remove them, and get them cleaned and/or rebuilt
also, do not forget when this is done to pour a little bit of oil in each housing to rebuild the compression, turn the engine 2-3 times by hand and dry the plugs before trying to start it
you might to check the engine's compression as well, to be sure of the engine's internals condition
if it was seriously flooded, I would highly recommend to change the oil since the fuel may has contaminated your oil.
if it's a spark problem, check if your high tension leads receive power. if yes, change plugs, if no, mostly it's gonna be a bad ground, faulty coils, or defective CAS
if its air problem, most of the time it is a defective AFM
that would be a good beginning.
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
turbo-minivan
General Rotary Tech Support
69
Feb 4, 2016 12:29 AM
The Shaolin
2nd Generation Specific (1986-1992)
9
Sep 14, 2015 07:50 PM



help needed i just bought an 87 w/13b but for some reason it wont run and keeps dumping fuel in the exhaust....anyone have any ideas on how to fix this?
