wire connector
#1
Who are you?
Thread Starter
Join Date: Mar 2003
Location: CenCal
Posts: 2,235
Likes: 0
Received 0 Likes
on
0 Posts
wire connector
what wire connector would this be? single connector
its on the right side of the oil filter(lookin at it from the drive side). wire connector is also on the right side of the engine <grease> nozzle!! the connector has this writing on it
0.117/250
R17G (white triangle here)
'F:
is this an engine ground?
its on the right side of the oil filter(lookin at it from the drive side). wire connector is also on the right side of the engine <grease> nozzle!! the connector has this writing on it
0.117/250
R17G (white triangle here)
'F:
is this an engine ground?
#3
Queer
Join Date: Mar 2001
Location: Formerly in the Ass end of the pacific.
Posts: 742
Likes: 0
Received 0 Likes
on
0 Posts
Hard to tell without a pic. Is everything on your car working correctly? With the car running test the wire for power. If there is no power, touch the wire and the chassis using the continuity tester and see if it beeps. If it does, you have a ground wire.
#4
Former Moderator. RIP Icemark.
Sounds like the oil pressure sender's condensor, it is a small black box right??? It should be screwed down to the clutch slave or the engine and plugged into the yel/red wire nearby.
And that "grease" fitting you mention is the bleeder for the Clutch slave. Please never ever put grease into that.
And that "grease" fitting you mention is the bleeder for the Clutch slave. Please never ever put grease into that.
#5
Who are you?
Thread Starter
Join Date: Mar 2003
Location: CenCal
Posts: 2,235
Likes: 0
Received 0 Likes
on
0 Posts
i didnt know what that bleeder nozzle was sorry!! anyway i think icemark ur right but for some reason the car stays running now on cold start up instead of stalling once!!
is there a write up on this oil pressure senders condensor? thanx again y'all the wire wasnt connected thats why i ask and the haynes manual didnt say anything about it!!
is there a write up on this oil pressure senders condensor? thanx again y'all the wire wasnt connected thats why i ask and the haynes manual didnt say anything about it!!
Thread
Thread Starter
Forum
Replies
Last Post
toplessFC3Sman
2nd Generation Specific (1986-1992)
6
03-20-18 01:54 PM