Wideband bung placement
Thread Starter
Joined: Sep 2002
Posts: 2,928
Likes: 1
From: Pittsburgh,PA
Wideband bung placement
I just got the Innovate LM-1 and I need a little help placing the bung on the rear of the downpipe.
If you are looking from the back of the downpipe 12 oclock being the top and 6 o'clock being the bottom, I know it need to be place somewhere between the 9 and 3 o'clock position. But where is best for clearnace issues? Closer to the 9 o;clock position?
If you have a pic of your install that would help out alot! Thanks!
If you are looking from the back of the downpipe 12 oclock being the top and 6 o'clock being the bottom, I know it need to be place somewhere between the 9 and 3 o'clock position. But where is best for clearnace issues? Closer to the 9 o;clock position?
If you have a pic of your install that would help out alot! Thanks!
Locust of the apocalypse
Joined: Apr 2003
Posts: 2,553
Likes: 2
From: Directly above the center of the earth (York, PA)
I think I had mine in the 2.5 oclock position... biggest reason was to get the wiring over to the fender without worring about it laying on the manifold.....
Thread
Thread Starter
Forum
Replies
Last Post
Turblown
Vendor Classifieds
12
Oct 17, 2020 03:25 PM
