who rebuilds switches?
12-21-11, 02:52 AM
#3
Full Member
Join Date: Dec 2011
Location: New Zealand
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
http://fc3spro.com/TECH/HOWTO/WIPER/wiper.html
My car JDM (RHD) so photos of switch inners were back to front (switch on different side of cluster obviously LHD) but i decifered the correct relay needed from omron here in NZ, got me a dremel bit,soldering iron and sorted mine. hardest part was removing the old relays pins with out damaging the circuit board(used a small drill bit to hand drill out the holes). But man...It is sooo good having 100% wipers front and back and the adjustable intermitted wiper .I suffered for years before...well worth it.
My headlight switch works fine.What goes wrong there LOL
My car JDM (RHD) so photos of switch inners were back to front (switch on different side of cluster obviously LHD) but i decifered the correct relay needed from omron here in NZ, got me a dremel bit,soldering iron and sorted mine. hardest part was removing the old relays pins with out damaging the circuit board(used a small drill bit to hand drill out the holes). But man...It is sooo good having 100% wipers front and back and the adjustable intermitted wiper .I suffered for years before...well worth it.
My headlight switch works fine.What goes wrong there LOL
Last edited by toyo kogyo; 12-21-11 at 02:56 AM.
12-21-11, 02:59 AM
#4
heh.. heh... Not JUST the switch, but the harness as well...
Make sure to clean any corrosion out of your front turn signal sockets and dielectric grease them before putting the bulbs in..
The only person I knew of that rebuilt the switches was Icemark [the guy peeking out of the rotor in the logo]...
Make sure to clean any corrosion out of your front turn signal sockets and dielectric grease them before putting the bulbs in..
The only person I knew of that rebuilt the switches was Icemark [the guy peeking out of the rotor in the logo]...
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Under PSI
3rd Generation Specific (1993-2002)
19
09-23-15 11:47 PM