where do these vacuum lines go on my t2
#1
Banned. I got OWNED!!!
Thread Starter
Join Date: Aug 2005
Location: abita springs LA
Posts: 256
Likes: 0
Received 0 Likes
on
0 Posts
where do these vacuum lines go on my t2
S4 turbo motor. With the UIM on the car and bolted down... If you look on the back of the UIM near the throttle body on the firewall side, there are 4 nipples for vacuum hoses.. The two closest to the top, where do they go? the very top one, and the one below It, I cannot figure out. I have looked at the FSM and do not understand it. Please just let me know where the run and how the run.
#3
HAILERS
Join Date: May 2001
Location: FORT WORTH, TEXAS,USA
Posts: 20,563
Likes: 0
Received 21 Likes
on
19 Posts
The top AIR hose is capped off.
The next AIR hose down is for the fuel injector air bleed nipple b/t the manifold oil injectors.
The third AIR hose down is for the oil injector air bleeds and should be going to a spider with five nipples.
The bottom nipple is a VACUUM hose and goes to the water thermo sensor for the throttle diaphram.
So...one cap, two air nipples and one vacuum nipple, top to bottom.
The next AIR hose down is for the fuel injector air bleed nipple b/t the manifold oil injectors.
The third AIR hose down is for the oil injector air bleeds and should be going to a spider with five nipples.
The bottom nipple is a VACUUM hose and goes to the water thermo sensor for the throttle diaphram.
So...one cap, two air nipples and one vacuum nipple, top to bottom.
Thread
Thread Starter
Forum
Replies
Last Post
Jeff20B
1st Generation Specific (1979-1985)
73
09-16-18 07:16 PM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM