What's need to hook a 13B Rew to TII Transmission?
#4
Sharp Claws
iTrader: (30)
you need to elaborate a little better, it also depends on what car it is going into.
FDs have a pull type slave cylinder which won't work on a TII tranny unless you really start getting creative with the bellhousing(swapping it out but then there is the difference in the shifter mechanis/location and missing sensors on the TII tranny that are needed for the FD) or making a hybrid system.
FDs have a pull type slave cylinder which won't work on a TII tranny unless you really start getting creative with the bellhousing(swapping it out but then there is the difference in the shifter mechanis/location and missing sensors on the TII tranny that are needed for the FD) or making a hybrid system.
#5
Laying Down Rotary Law
well I got a TII with a rew engine now
using the stock TT tranny
I just used my FC ACT extreme clutch kit on the FD wheel
as per my mechs instructions and everything bolted up nice
using the stock TT tranny
I just used my FC ACT extreme clutch kit on the FD wheel
as per my mechs instructions and everything bolted up nice
#6
Moderator
iTrader: (7)
for TII transmission on REW
a) S5 TII flywheel/clutch
b) S5/FD automatic counterweight and some aftermarket flywheel/clutch combo suited for TII
pressure plate and clutch disc must match the transmission, flywheel/counterweight must match rotors (and S5 TII and FD rotors are same)
a) S5 TII flywheel/clutch
b) S5/FD automatic counterweight and some aftermarket flywheel/clutch combo suited for TII
pressure plate and clutch disc must match the transmission, flywheel/counterweight must match rotors (and S5 TII and FD rotors are same)
Trending Topics
#8
Registered Loser
iTrader: (6)
Join Date: Dec 2002
Location: Whiterock
Posts: 2,224
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by kabooski
Yes FD flywheel and a TII clutch
here is my new Half-Bridge/ Ported built REW motor with a TII front cover (work in progress)
[img]http://cfiracing.com/albums/album02/pic.jpg[/mg]
here is my new Half-Bridge/ Ported built REW motor with a TII front cover (work in progress)
[img]http://cfiracing.com/albums/album02/pic.jpg[/mg]
custom or aftermarket mounts?
#10
Laying Down Rotary Law
http://www.motivefab.com/
makes them, good quality
It will look even better after I clean up the engine bay
and tighty everything up and install the rest of the setup
this was just a sneak peak of the mock up
makes them, good quality
It will look even better after I clean up the engine bay
and tighty everything up and install the rest of the setup
this was just a sneak peak of the mock up
Last edited by kabooski; 01-14-07 at 05:29 PM.
Thread
Thread Starter
Forum
Replies
Last Post
KAL797
Test Area 51
0
08-11-15 03:47 PM