I know that I need to use a TII flywheel but what about the counterweight ?


Lupe

 

you need to have an FD or S5 TII stock flywheel flywheel or counterweight.

 

So, with a 3rd gen motor and TII transmission. I can use a stock 3rd gen flywheel ? That's it?

 

you need to elaborate a little better, it also depends on what car it is going into.

FDs have a pull type slave cylinder which won't work on a TII tranny unless you really start getting creative with the bellhousing(swapping it out but then there is the difference in the shifter mechanis/location and missing sensors on the TII tranny that are needed for the FD) or making a hybrid system.

 

well I got a TII with a rew engine now
using the stock TT tranny
I just used my FC ACT extreme clutch kit on the FD wheel
as per my mechs instructions and everything bolted up nice

 

for TII transmission on REW

a) S5 TII flywheel/clutch
b) S5/FD automatic counterweight and some aftermarket flywheel/clutch combo suited for TII

pressure plate and clutch disc must match the transmission, flywheel/counterweight must match rotors (and S5 TII and FD rotors are same)

 

Yes FD flywheel and a TII clutch

here is my new Half-Bridge/ Ported built REW motor with a TII front cover (work in progress)

 

nice setup

custom or aftermarket mounts?

 

that is sexy, black and red... MMMMMMM

 

http://www.motivefab.com/

makes them, good quality

It will look even better after I clean up the engine bay
and tighty everything up and install the rest of the setup
this was just a sneak peak of the mock up