what vacum lines to use?
#1
Rotary Enthusiast
Thread Starter
what vacum lines to use?
when hooking up the solenoid valve, what vacum lines do i use?
where is the wastegate so that i can put the nipple on there that is suppplied with the avcr kit?
do i just use the stock place for hte pressure sensor vacum line?
meaning fdo i put the new one where the old one is hooked up?
it says tht there is suppose to be a line going from the intake after the turbo to the watstegate? is this the one i use or what?
help please
where is the wastegate so that i can put the nipple on there that is suppplied with the avcr kit?
do i just use the stock place for hte pressure sensor vacum line?
meaning fdo i put the new one where the old one is hooked up?
it says tht there is suppose to be a line going from the intake after the turbo to the watstegate? is this the one i use or what?
help please
#4
Full Member
Join Date: Aug 2001
Location: Burlington, VT
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Are you trying to remove the air control valve? I just did that a week ago, and it's not too bad. You need to drill a hole in the block off plate, and put a nipple in it. I used the new gasket to find where to drill the hole. It's the one next to the top bolt. It gets connected to the boost guage on the right front strut tower.
If it is something else you are trying to accomplish, people may need a better explanation.
Hope this helps....
-Jason
If it is something else you are trying to accomplish, people may need a better explanation.
Hope this helps....
-Jason
Thread
Thread Starter
Forum
Replies
Last Post
Tem120
3rd Generation Specific (1993-2002)
4
09-07-15 09:53 AM
Nosferatu
2nd Generation Specific (1986-1992)
7
09-05-15 02:13 PM