As the title says. I am waiting for some parts to come in before I put my car back together. Any suggestions on what I should do since the UIM is off?

I have already done the following:
-replaced fuel lines
-replaced all vac lines with silicon hoses
-replaced coolant hoses
-used new screw type hose clamps
-checked injectors
-have new orings and grommets for injectors coming
That's all I can think of right now.

Any suggestions welcome.

 

check your sensors.

 

Want to try polishing my UIM with your new air tools? I have an SAFC to install tomorrow also.

 

sounds good. i got the day off tomorrow

 

port the hech outta the intake / tb

 

Do the TB Mod, remove the rats nest, block off EVERYTHING, etc..

BTW, how long does it take to polish with airtools? I'v been polishing **** with a dremel and it sucks..

 

Unbolt and clean up the main EFI ground bolted to the top of the engine.

 

I think I'll save that for another time but thanks for the suggestion.

I already did this by sanding the ring connector as well as the surfaces where it meets on the engine. I suppose I should add an extra ground as well.

 

um, all about porting the intake and TB

 

ooooooo TB porting....we should port bouth our TB's

 

Since my car will be down for a few days we might. I'm still at home and won't be back til 6:30 so if you want to pull your tb too we could do it. I already pulled off my OMP and ACV so I dont really have anything to do other than install the SAFC and porting or polishing. Do you have any JB weld, I ran out. Call me if anything.

 

good time for powder coating.

Polishing's great ... unit it gets dirty again and then it looks like @$$.

 

ehh...my hands hurt still from that engine swap. ya i got jb weld

 

get your injectors cleaned and blue printed you will be happey with that