OK here is the scoup.

86 n/a 5spd

currently removing omp, rats nest, cold start assist, egr

LEAVING the thermo wax and the bac valve

I have this sitting in the engine bay and for the life of me cant remember what it goes to and if I need to keep it





Today if weather permits I plan to get the block off plat over the omp, run the last fuel line, run two new vac hoses and put the mim and uim back on. possibly start the car. but I need to know if I need this..

thx in advance

 

I believe it's the BACV (you can find it in the FSM to double check me). If you send me pizza, I'll tell you the rest.

 

ok Ill send pizza lol... tell me the rest lol

 

btw thats not the bac valve but it was under it I think

 

It's the air bypass solenoid located on the left side of the n/a engine on a eighty six car. It works with the air bypass relay to cause a high idle during cold starting and it opens only for 17 seconds during that event.

It's not NEEDED but then again, it ain't hurting anything sitting there. It's up to you.

 

And that's why I put up a disclaimer about being wrong...

Isn't it on the right side though? Hmmm, I should say driver's. I always think from looking from the bumper.

 

drivers is left... it was on that side.. this means I will remove it thx guys

Dave

 

Left, right, whatever.

Do I still get pizza because I tried?

 

lol I'll buy u a pizza the next time u visit

 

And that's why the forum's full of wrong answers and confused people. Why didn't you check the FSM before posting?