What do i gotta be carful with when im porting?
I got a good port template but i never done a portjob before.
Anyone got some "this is correct, this is wrong" pictures?

Thanks,
Sindre

 

I don't have any pics, but... you have to watch out for the water jacket.. you also have to make sure not to get overly ambitious and grind too far in either direction. But, I'll know more when I do it this coming month.

 

The main issue for the first time porter is knowing how car to go when enlarging the actual port bowl. So start with a template, and be VERY CONSERVATIVE when you taper the port walls to the size of the new opening. At the top, you can make a smooth angular transition without worrying too much (there's almost 1/4" worth of material) but on the bottom you have to be more careful. On the bottom, "roll" the transition so you are not actually griding away more then about 1/8" of material from the bottom of the port wall. Especially on the intermediate housing, you run into the water jacket very quickly.

Aside from that, it's straightforward if you are just doing your first job. Follow the template and make sure to protect the area around the port with thick duct tape to avoid accidents. Don't move the port inwards at all under any circumstances. The runners should be smoothed slightly but still need texture. Do not enlarge the runners.

 

Thank you for a great input!
should it look like this?
http://home.iprimus.com.au/bluey3/po...portstreet.jpg

 

That looks like an early 13B/12A casting, so there is a little less area to work with (hence the long tapered section). With most street port templates on 2nd gen irons, the taper won't have to be that extreme.

 

okey, ill take it slowly so i dont **** it up. I have the equipment to measure the thickness of material so i can be sure the wall is thick enaugh. I washed the parts today so im gonna start porting tomorrow. Ill take so pictures so you guys can look at it when im finnished.