water thermo sensor
#1
Rotary Enthusiast
Thread Starter
iTrader: (14)
Join Date: Mar 2009
Location: the dalles
Posts: 1,161
Likes: 0
Received 0 Likes
on
0 Posts
water thermo sensor
is there any way around this thing? mine was busted when the PO replaced the alternator. now its a b word to try and start in the cold. what can i do to fix this. btw its broken on the harness side of the plug. and its a S4 NA
#2
rotorhead
iTrader: (3)
the s4 water themo sensor plug is the same plug as the BAC valve or the 88 injectors: square plug with an offset tab.
buy another plug here: http://www.rx7store.net/product_p/injector%20clips.htm or get one at carquest. tell them you need a Bosch fuel injector pig tail.
Those connectors have a center locating tab instead of an offset one (impossible to find the offset ones), so you will need to file the tab off altogether. IT's on the bottom part of the water thermosensor plug.
I have done this exact repair procedure on a BAC valve connector. But I actually depinned the broken BAC valve connector and inserted the pins into a new connector without cutting anything.
buy another plug here: http://www.rx7store.net/product_p/injector%20clips.htm or get one at carquest. tell them you need a Bosch fuel injector pig tail.
Those connectors have a center locating tab instead of an offset one (impossible to find the offset ones), so you will need to file the tab off altogether. IT's on the bottom part of the water thermosensor plug.
I have done this exact repair procedure on a BAC valve connector. But I actually depinned the broken BAC valve connector and inserted the pins into a new connector without cutting anything.
Thread
Thread Starter
Forum
Replies
Last Post
mulcryant
2nd Generation Specific (1986-1992)
10
09-09-15 05:24 PM