wat PP to use?
Thread Starter
Joined: Jul 2003
Posts: 2,601
Likes: 0
From: Jefferson City, Tn
wat PP to use?
hey guys quick question what kind of pressure plate do you suggest to use with a 6 puck unsprung clutch??? it for autocrossing only...
TwEaK
TwEaK
Locust of the apocalypse
Joined: Apr 2003
Posts: 2,553
Likes: 2
From: Directly above the center of the earth (York, PA)
Depends... Turbo or N/A??
Turbo... go with the XT (like 430 ft lb or some ****.. your leg will FEEL it after a day on the track!!!!)
N/A.... Go with the heavy duty
Turbo... go with the XT (like 430 ft lb or some ****.. your leg will FEEL it after a day on the track!!!!)
N/A.... Go with the heavy duty
Thread Starter
Joined: Jul 2003
Posts: 2,601
Likes: 0
From: Jefferson City, Tn
its an N/A but act what??? my rotary mechanic has a bunch of pressure plates brand new so i dont know which one i need exactly or what do i tell him ??? i need a heavy duty pressure plate for a 13b n/a ?
TwEaK
TwEaK
Joined: Nov 2002
Posts: 1,790
Likes: 3
From: Travis AFB, CA to Okinawa, Japan
An ACT heavy duty PP should be ok for that. Just a little warning the pedal will get heavy and its a good idea to change out the slave and master cylinders and throw in a stainless clutch hose with ACT PP's. After installing mine I blew the slave cyl after a week. Then a week later the master cyl went.
What other PP's are you looking at?
What other PP's are you looking at?
Thread Starter
Joined: Jul 2003
Posts: 2,601
Likes: 0
From: Jefferson City, Tn
well ive only used ACT's and ive been happy with them ever since the slave cylinder is shot already so i gotta replace that neways SS clutch line ne idea where i can buy those at??? i was looking at the ebay specials but dont know if there any good?
TwEaK
TwEaK
Thread
Thread Starter
Forum
Replies
Last Post
DJ!
1st Generation Specific (1979-1985)
3
Nov 11, 2002 11:57 PM
Rotary81z
3rd Generation Specific (1993-2002)
4
Jan 16, 2002 10:35 PM