When rebuilding the engine is it a good idea to replace the oil injecter lines and all the vacume lines? Alot of the vacume lines just slid right off where as most I had to break the seal so to speak. I would hate to get this back together and have to hunt down a leak with all these hoses, but then again they seem almost preformed ( or bent ) where used.

 

ok it should be injector lines

 

yes

 

might as well. its going to be a lot easier to do it now than when everything is fully assembled. replace/remove as much of that crap as you can.

 

some may be preformed from the factory, but if you can get new lines from a roll to fit right without kinking they seem to take to their new shape in time. so as long as you can make them fit and still flow there should be no problem.

 

What type, and where do I get the oil Line? I suppose the clamps will pretty much be available where I get the lines from.

 

http://www1.mscdirect.com/cgi/nnsrhm

For the exact part numbers and how to, check out this thread
https://www.rx7club.com/showthread.p...=injector+size

 

Awsome help guys, Thanks