Unable to shift into 1st, 3rd, and 5th?
#1
Black 1989 Convert.
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Downingtown, PA
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
Unable to shift into 1st, 3rd, and 5th?
During a drive my transmission stopped letting me shift into first, third, and fifth gears. It wasnt a gradual increased difficulty, it was just all of a sudden. It happened once before, but it self corrected after a minute. I have driven about 25 miles since it started doing this and it hasnt changed. I am low on gear oil, so is that likely the problem?
#4
rotary tech
iTrader: (9)
Join Date: Jan 2007
Location: tracy/stockton ca
Posts: 795
Likes: 0
Received 0 Likes
on
0 Posts
good chance that since your low on gear oil you syncros are poorly lubricated. since it self corrected last time i would try putting in some lucus syncro mesh and then topping on the tranny with good new gear oil. and see if that helps first. i say go with the cheaper fixes first it might work instead of going after a full tranny rebuild now.
#6
Black 1989 Convert.
Thread Starter
iTrader: (1)
Join Date: Jul 2006
Location: Downingtown, PA
Posts: 232
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the reply. Would autozone have good enough gear oil for now? I am a few hours away from home, and dont have a single tool to use, so I am hoping that putting in the oil fixes it.
Thread
Thread Starter
Forum
Replies
Last Post
REX7&Z32TT
New Member RX-7 Technical
5
09-09-15 05:16 AM