2nd Generation Specific (1986-1992) 1986-1992 Discussion including performance modifications and technical support sections.

turbo swap running but......?

Thread Tools
 
Search this Thread
 
Old Apr 29, 2007 | 12:23 PM
  #1  
sktrowley's Avatar
Thread Starter
Full Member
Tenured Member 15 Years
 
Joined: Feb 2005
Posts: 82
Likes: 0
From: Wichita, Kansas
turbo swap running but......?

the car: 86 base model
motor: jdm s4 w/ NA wire harness, all emisions removed (except OMP), banjo bolt, replaced all fuel o rings, new walbro pump, had the injectors flow tested-passed, and a new fuel filter(the car had been sitting in my garage for about a year and a half.

ok so the problem i am having is the car starts everytime and idles (decent) at around 1200, but if i touch the gas it will either cut out and die or rev then die.
I have redone all the rvt on the block off plates. I
My thought was timing but if i turn the idle down under 1100ish it wont idle at all.

Any ideas would be awesome
thanks Casey
Reply
Old Apr 29, 2007 | 01:04 PM
  #2  
Rx7TyreBurna's Avatar
Becoming pure track...
Tenured Member 15 Years
iTrader: (1)
 
Joined: Feb 2005
Posts: 1,069
Likes: 0
From: Olympia, WA
I would say double check TPS, but I am not sure if it can be checked when it's cold.

Good luck.
Reply
Related Topics
Thread
Thread Starter
Forum
Replies
Last Post
trickster
2nd Generation Specific (1986-1992)
25
Jul 1, 2023 04:40 PM
bb6guy
Old School and Other Rotary
10
Oct 1, 2018 08:07 AM
Machupicchu
1st Generation Specific (1979-1985)
8
Aug 17, 2015 08:27 PM
Professorpeanutrx7
New Member RX-7 Technical
5
Aug 15, 2015 01:38 PM




All times are GMT -5. The time now is 08:20 PM.