New to Rotary engines so this may be a dumb question but looking to throw a turbo on the rx7 and was wondering if there are any advantages to swapping in a TII motor and upgrading vs just throwing a kit on the 13b?

 

Search through the archives to find a lot of info on this.

Much easier to swap motor & trans. Bolting a turbo onto a NA motor requires a lot of custom fabrication, usually a standalone EMS, and is far more difficult.

 

Copied directly from the FAQ:

Can I swap a Turbo engine/Jspec engine/13BT/etc into my Non Turbo?
Yes, check these links:
https://www.rx7club.com/forum/showth...threadid=26647
http://www.rotaryresurrection.com/ro...conversion.htm


What Turbo kits can I add onto my non turbo RX-7?
There are no longer kits formally made at the time of this post, however there are companies from time to time that do make available non turbo to Turbo Kits. Because most of these companies stop building the kits, or go out of business in short time, it is impossible to keep active links for them.

Most people that turbo a non turbo make their own kits:
Using the stock TII turbo, exhaust manifold with spacer, NA intakes and NA ECU:
http://www.aaroncake.net/rx-7/naturbo.htm
https://www.rx7club.com/forum/showth...threadid=88540

https://www.rx7club.com/forum/showth...threadid=88758
https://www.rx7club.com/forum/showth...hreadid=124232
http://users2.ev1.net/~ccoutts/turbo..._a_project.htm

Using the stock TII turbo, exhaust manifold, intakes, ECU:
http://forum.teamfc3s.org/showthread.php?t=37694

Turbo-NA Forum:
http://www.aaroncake.net/forum/forum...urbocharged+NA

Thread closed.