trans/clutch prob -- Squeaks
Thread Starter
Full Member
Joined: Aug 2003
Posts: 136
Likes: 0
From: FL
trans/clutch prob -- Squeaks
Please Help!
This is so annoying. When I put in gear and start to go, there is a little squeaking noise. It also does it w/ the clutch being engaged and the car just rolling(1-2mph), but it doesn't make noise if it is not in gear.
Please tell me if you know what this is. The clutch was replaced by the mazda dealer like 25,000mi ago.
Could this be the trans fluid?
This is so annoying. When I put in gear and start to go, there is a little squeaking noise. It also does it w/ the clutch being engaged and the car just rolling(1-2mph), but it doesn't make noise if it is not in gear.
Please tell me if you know what this is. The clutch was replaced by the mazda dealer like 25,000mi ago.
Could this be the trans fluid?
Last edited by rotarypower86; Nov 26, 2003 at 11:58 AM.
Locust of the apocalypse
Joined: Apr 2003
Posts: 2,553
Likes: 2
From: Directly above the center of the earth (York, PA)
Pull your driveshaft out and check the universal joints... could be cause by a dry socket and the torque from the engine, will transfer through the tranny to the bell housing and be mangified by the bell housing. Might not make any noise when the clutch is in because there is no torque on the drive shaft. When you have the driveshaft out... check your tranny fluid level as well.
Thread
Thread Starter
Forum
Replies
Last Post
immanuel__7
2nd Generation Specific (1986-1992)
89
Sep 5, 2015 10:23 AM
fastrotaries
2nd Generation Specific (1986-1992)
3
Nov 27, 2001 04:50 PM