torrington thrust bearing
#1
Senior Member
Thread Starter
iTrader: (7)
Join Date: Jul 2008
Location: ohio
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
torrington thrust bearing
I was reading on Mazdatrix about the torrington thrust bearing and I was wondering if you take off the four bolts that hold the pulley on will that mess that bearing up or is it only if you take the front eccentric shaft bolt lose that it will mess the bearing up. This has me worried that I messed my front bearing up because I took my front pulley off to paint it.
#2
Too old for this
You only have to worry about those bearings if you take the main e-shaft bolt out. If you just pulled the 4 little bolts that bolt the pulleys onto the front hub, you're fine.
#3
Senior Member
Thread Starter
iTrader: (7)
Join Date: Jul 2008
Location: ohio
Posts: 253
Likes: 0
Received 0 Likes
on
0 Posts
Thanks for the help makes me feel better to know I did not damage anything. That is what I thought it was only if you take the e-shaft bolt off you would mess things up. I just wanted to double check my shelf to make sure I was right.
Thread
Thread Starter
Forum
Replies
Last Post
ls1swap
3rd Generation Specific (1993-2002)
12
10-01-15 07:58 PM